|
Oil / Water Temperature Sensor Kit - Operating Temp: -20C to 150C / -4F to 302F - Sensor Body Material: Brass - Thread: 1/8" NPT - Hex Size: 1/2" - Installation Torque: 13.5Nm / 10 ft-lbs - 6' Flying lead made of Tefzel premium wire and Raychem ... Part No: U2-OW-TSK |
- Used to measure fluid pressure and temperature Pressure Range 0-150 PSI Temperature Range -40 to 140 Deg C - Simple all in one unit - Connector with 6' Flying lead made with only the best Tefzel wire and Raychem DR-25 - 25 mm P-Clip Mount with Stainless M6 Bolt - 1/8 BSP to 1/8 NPT - 1/8 NPT to -4 - -4 pre made line 12" length - 1200' heat sleeving for the first 6" - ALL READY FOR ... Part No: U2-BOSCH-FP-TS-RM |
Bosch Fluid Pressure and Temperature Sensor ( Sensor Only ) - Used to measure fluid pressure and temperature Pressure Range 0-150 PSI Temperature Range -40 to 140 Deg C - Simple all in one unit - Connector with 6' Flying lead made with only the best Tefzel wire and Raychem ... Part No: U2-BOSCH-FP-TS-S |
-K-Tuned B series TPS Adapter -Premium aftermarket B series TPS Sensor -Tefzel Motorsports Wire -Raychem DR-25 Heatshrink Sleeving -Female 3 Pin connector ready to plug in K series TPS Sensors... Everyone knows they are a problem. So we've tried to make your life a little easier. Over the years we have tried pretty much every single k series TPS in existence with none of ... Part No: U2-BSERIES-TPS-K |
150 PSI Stainless Sensor Kit - Sensor Body: Stainless Steel - Thread: 1/8" NPT Male Thread - Output: .5 to 4.5Vdc Linear - Includes: 150 PSI Stainless Sensor - 1/8" NPT to -4 Adapter - 6' Flying lead made with premium Tefzel wire and Raychem DR-25 - Premium Push in connector, NOT PULL ... Part No: U2-150PSI-SSK-L |
0-150 PSI Pressure Sensor Connector with Flying lead made with only the best Tefzel wire and Raychem sleeving 25 mm P-Clip Mount with Stainless M6 Bolt 1/8 BSP to 1/8 NPT 1/8 NPT to -4 -4 pre made line 12'' length 1200' heat sleeving for the first 6'' 0-150 PSI Pressure Sensor Connector with Flying lead made with only the best Tefzel wire and Raychem sleeving 25 mm ... Part No: U2-150PSI-PSK-RM |
Applications: All K-Series engines Fits K-Tuned Throttle Bodies Note: * Excludes K24Z-Series Engines * Requires engine management to use (Flashpro/K-Pro/S300/AEM) * We offer a 1 Year Warranty with all MAP sensors * We offer a 1 year warranty with all MAP Sensors. K-Tuned 4 BAR MAP Sensors are designed to accurately read the increased manifold pressures on turbo or supercharger setups and ... |
Applications: 12-15 Civic Si 13+ ILX 09-10 TSX CU 06-11 Civic (R18 Motor) 06-09 S2000 AP2 11-13 CR-Z Note: * Requires an engine management (Flashpro/Kpro/S300/AEM) * We offer a 1 Year Warranty with all MAP sensors K-Tuned 4 BAR MAP Sensors are designed to accurately read the increased manifold pressures on turbo or supercharger setups and will reliably support ... |
Applications: 88-91 Civic EF 92-95 Civic EG 96-00 Civic EK 90-93 Integra DA 94-01 Integra DC 92-96 Prelude BA 07-01 Prelude BB 00-04 S2000 AP1 94-97 Accord CD 98-02 Accord CG Note: * Requires an engine management (Flashpro/Kpro/S300/AEM) * We offer a 1 Year Warranty with all MAP sensors K-Tuned 4 BAR MAP Sensors are designed to accurately read the increased manifold pressures on turbo or ... |
AEM's Bosch 4.9LSU Wideband UEGO O2 replacement sensor kit includes only the sensor (with attached cable and male connector) and is intended to replace an existing mounted wideband sensor used with AEM Digital Wideband UEGO Air/Fuel Controller Part Number 30-4110. These sensors have a laser-etched, calibrated resistor in the sensor's connector body. This resistor is specifically created for ... Part No: aem30-2004 |
The Hondata 4 port boost controller precisely directs pressure to the top and bottom of your waste-gate diaphragm. It allows much lower waste-gate spring pressure for better low gear boost control and perfect high gear, high boost control. Features: *A 10 lb waste-gate spring will enable 50+ psi of boost *Better spool-up and mid range power *Better duty cycle control For use with: *S300 ... Part No: HDAT-4PRT-BC |
AEM offers several sensor and Plug & Pin connector kits for vehicles that require additional outputs and/or upgraded hardware over existing sensors. Available sensors include boost/backpressure sensors, exhaust gas temperature (EGT) sensors, nitrous oxide/brake pressure sensors, UEGO replacement sensors, inlet air temp sensors (IAT), K-Type sensors and more. All sensors come with a three- ... Part No: AEM-30-2001 |
... Part No: aem30-2131-30 |